Cover image for Correlations of mud rheological properties with cuttings-transport performance in directional drilling
Title:
Correlations of mud rheological properties with cuttings-transport performance in directional drilling
Personal Author:
General Note:
SPE Drilling Engineering. 6 (1) : 16-24 ; March 1991
Abstract:
An experimental study comparing the effects of mud rheological parameters onannular drill-cuttings buildup was conducted in a large scale flow section. Rheological parameters examined were mud yield point (YP); plastic viscosity(PV); YP/PV ratio; power-law exponent; consistency index; Fann tm V-G Meter dial readings at 600, 300, 200, 100, 6, and 3 rev/min; effective viscosity (calculated by the power-law derivation); and initial and 10 minute gel strengths. Fifteen bentonite/polymer water-based muds were used, ranging from water to a mud with YP and PV values of 20 Ibf/100 ft 2 and 40 cp [19.6 Pa and 0.04 Pa's], respectively. For each mud, flow tests were run at annular velocities from 120 to 240 ft/min [37 to 73 m/min] and hole angles from 30 to 90 deg from vertical. The effective drilling rate for all tests was 50 ft/hr [15 m/h]. Altogether, 180 tests are analyzed. When data were correlated with annular cuttings volume in steady-state flow, the best fit was obtained with low-shear-rate parameters. These parameters include the 6- and 3-rev/min dial readings and initial gel strength. Correlation coefficients for these wereoften from 0.9 to 0.95. For hole angles <45 deg (from vertical), increasing values of these parameters improved cuttings removal (i.e., reduced cuttingsvolume). The same was observed at angles near horizontal, but only in the laminar flow regime. Cuttings volumes were always smaller in the turbulent regime during near-horizontal flow.

Available:*

Library
Item Barcode
Call Number
Material Type
Item Category 1
Status
Searching...
30000000868996 MAK 3830 Open Access Book Article
Searching...

On Order